R-SL-FIX-SBS Mounting Adhesive SBS

Mounting Adhesive SBS - universal with very good adhesion. Recommended for mounting and finishing works.

Features and benefits

  • Very good adhesion to wood, MDF, HDF, concrete, plaster, brick, metal, glass, hard PVC, and the most common materials  in the building industry
  • High bonding strength
  • Remains flexible after hardening
  • Ideal for renovations and finishing works
  • Fast curing and effective penetration of the substrate

Contact us to get information about product availability and its price

Fill in the form with your details and send request for a R-SL-FIX-SBS Mounting Adhesive SBS

Your request will be sent to our sales department. Please note this is not a purchase order.

    Base material

    • Concrete


    • Masonry


    • Wood


    • Plasterboard


    • Oriented Strand Board

      Oriented Strand Board

    • High-Density Natural Stone

      High-Density Natural Stone

    • PVC Profile

      PVC Profile

    • Glass


    For use also with

    • Solid Concrete Block

      Solid Concrete Block

    • Hollow-core Slab

      Hollow-core Slab

    • Concrete Slab

      Concrete Slab

    • Aerated Concrete Block

      Aerated Concrete Block

    • Lightweight Concrete Block

      Lightweight Concrete Block

    • Hollow Lightweight Concrete Block

      Hollow Lightweight Concrete Block

    • Silicate Blocks

      Silicate Blocks

    • Hollow Brick

      Hollow Brick

    • Vertically-perforated Clay Block

      Vertically-perforated Clay Block

    • Hollow Sand-lime Brick

      Hollow Sand-lime Brick

    • Solid Brick

      Solid Brick

    • Solid Sand-lime Brick

      Solid Sand-lime Brick

    • Ceramic Hollow Block

      Ceramic Hollow Block

    • Gypsum Fibreboards

      Gypsum Fibreboards

    • Chipboard


    • Metal Sheet & Profiles

      Metal Sheet & Profiles

    Installation guide

    Installation guide
    Installation guide
    Installation guide
    1. The surface, that adhesive will be apllied on, should be clean, free of dust, grease, rust, remains of old seal and other substances that might weaken the cohesion.
    2. Cut the tip of the cartridge, leaving part of the thread. Screw the applicator on to the thread, then cut at the required angle to give an aperture width suited to the joint.
    3. Place the cartridge in the extruding gun and apply the adhesive with manual or pneumatic gun.
    4. Apply drops or strips of adhesive on the glued surface and spread thoroughly. Join the surfaces and disconnect. Wait 5 minutes. stick together again and press firmly.
    5. The joint achieves its ultimate strength in 1-7 days, dependingly on the type of material, layer thickness and conditions. The placement of the glued piece can be amended only by move it witout disconnecting.
    6. After completing the application, wipe tools with a paper towel and clean with solvent.


    Need documents for other product? Visit our Technical Library.

    go to library
    Go to top